Something along these lines, would be nice, not keen on the finish or location though.
Amps is that shot taken after the Dominic Cummings garden of No10 press conference and the party that followed…?
Millsy LOL
If its bespoke then measure the width of all your equipment then add maybe ½″ either side plus extra for the ends. If you’ve got a lot of vinyl which will be stored underneath then that needs to be taken into account also.
Amps cheers - no, plan to have a shelf across the top of the decks - seen a really good looking one
Work tables seem quite good for a home DJ set up, just need to figure out the monitor-situation. But they’re sturdy, right height, and don’t cost a fortune.
All a bit of a mare getting a table specific to my needs. I’ve got our old builder coming round and building one for me - will work at much cheaper and to my exact specs.
Along_the_Wire that’s sweet. Might do that at some point, I have a really specific desing on my mind too. My current one is a Frankenstein’s monster of Ikea and other cheap shelves held together with a large piece of glued laminated timber board.
Along_the_Wire The height of the table is key. Give yourself at least 100cm height
Along_the_Wire I’ve got our old builder coming round
FAO @Smallman1
Homegrove Cabinet builder is what you want, over a carpenter / builder / Darren. My next one will be a bespoke build, might be a good few years away though. Want one with a proper decent lid, removeable interior surfaces etc.
seanc80 yeah, got some advice on here about that a while back - going for 104cms
mono-stereo LOL
Lol!
…ridiculous collab aside, I’d quite like to check this stuff out. The regular Kallax shelving is pretty good when slightly modified, and this new stuff is optimised for DJ kit in terms of height/width.
https://about.ikea.com/en/newsroom/2022/09/08/ikea-to-launch-the-obegransad-collection-in-collaboration-with-swedish-house-mafia
Unbroken1 Can’t believe it’s took them so long to do this. They’ve been sat on a fortune with this stuff for years.
…are you going ‘modular’ Grant?
Out of the ironing cupboard into the fire! 😆
Unbroken1 Out of the ironing cupboard into the fire! 😆
Unbroken1 what does modular mean?!
Preference is kit on a desk, don’t want stuff sunk as I’ve seen many times
…always favoured a made-to-measure studio desk over a fitted console (not practical when you change kit as often as I do!), liked the look of these, but may not be wife-friendly dependent on your decor https://chunkystudiofurniture.co.uk
Unbroken1 Some nice desks on offer!
Along_the_Wire ..separate decks and mixer as opposed to an all-in-one controller.
Yep, agreed on the desk for the same reason.
Dan …yeah, deffo. The new ‘shelving unit’ (or ‘JONJO’) looks decent. There was a mod where you could put the Kallax TV stand inverted on the top of the shelves than looked similar, but this is much neater obv.
